29 questions
Most triedMost missedNewest- What should you wear when using a lathe or drill?
- Long hair in the workshop should be…
- The first stage of the design process is usually…
- A specification is…
- Which is a hardwood?
- Which is a ferrous metal?
- Which plastic softens when heated and can be reshaped?
- Which saw is used for cutting curves in thin wood?
- Which saw is used to cut metal?
- Which tool marks a line parallel to the edge of a piece of wood?
- Which joint is commonly used for strong corners in a drawer?
- Joining metals with a molten filler of lower melting point (e.g. solder) is…
- Which drawing shows an object at 30° to the horizontal?
- In orthographic projection, the views usually shown are…
- A thin chain line (long dash, short dash) on a drawing shows a…
- A beam supported at only one end is a…
- Triangulation makes a frame structure…
- A lever with the fulcrum between the effort and the load is a…
- A gear with 10 teeth drives a gear with 40 teeth. What is the gear ratio?
- Which mechanism changes rotary motion into reciprocating motion?
- Which wood finish protects outdoor furniture best?
- Anthropometrics is the study of…
- Ergonomics is about…
- Which property describes a material's ability to be drawn into a wire?
- Which process shapes hot plastic sheet over a mould using suction?
- A COSHH label or symbol warns about…
- Design a stand to hold a cellphone on a study desk.
- A small business makes school desks from mild steel tube and pine.
- A learner is making a bookshelf.